Discountable

M10-5883 uses multi-constellation GNSS powered by u-blox MAX-M10S. MAX-M10S supports concurrent reception of four GNSS (GPS, GLONASS, Galileo, and...

M10-L4-3100 is based on ArudPilots’ AP_Periph firmware,  It is a GNSS+COMPASS+BAROMETER peripheral with CAN/DroneCAN and UART/MSP interfaces. M10-...

Matek M8Q-5883 GPS and Compass Module perfect for fixed wing using iNAV.A Very small size GPS module perfect for when your restricted for room a...

The Matek H743-SLIM Flight Controller features STM32H743VI, ICM20602 & MPU6000, DPS310, OSD, 7x UARTs, 2x I2C, 1xCAN, 13x PWM outputs, BEC5V an...

Matek's H743-WING V3 Flight Controller arrives with new features and improvements over the original. This FC features a STM32H743VIT6 MCU running ...

Specifications Hall effect current sensor No voltage drop and heat on current sensor components Offset and Sensitivity are calibrated in factory C...

Get the voltage you need with this Matek BEC, convert 6-25V to either 5V, 9V, or 12V. This BEC defaults to 5V, select either 9V or 12V by solderin...

Specifications Optical Flow: PMW3901 Lidar: VL53L0X Interface UART Protocol: MSP Working Range: 8cm~200cm Field of view: 42 degree(PMW3901), 27 d...

PDB Input voltage range: 6~60V (2~12S LiPo) PDB/current sense resistor: 140A cont, 264A burst. ESC power pads: 60A cont. 100A burst 6x ESC power /s...

Wide 9V to 55V Operating Input Range with TVS protection 3x independent Step-Down Voltage Regulators BEC Vx,  5.2V / 6V / 8V output options.  supp...

Specifications 9V to 55V Operating Input Range Vx for servos,  5V, 6V, 8V Adj. Default is 5V. Synchronous switching step-down (buck) regulator w...

FEATURES High Efficiency Synchronous Step-down regulator Wide 2-8S (6-30V) Operating Input Range Continuous load current: 1.5 Amps (Max.2.5A 5s/min...

FEATURES High Efficiency Synchronous Step-down regulator Wide 2-8S (6-30V) Operating Input Range Continuous load current: 1.5 Amps (Max....

UBEC DUO 4A/5~12V & 4A/5V This device is a high-efficiency, switch-mode buck regulator with two output channels. It works with 7~26Vdc input. ...

9CH INTL and 2CH US version have identical hardware and layout,  2CH is locked to 1258 & 1280MHz by firmware. Features & Specifications ...

200A - Current / Voltage measurement sensor board, based on Allegro Hall Sensor ACS758-200U.Voltage range is up to 20S (85V) with solder bridge ope...

GeneralThe HYB-BEC (Hybrid BEC) is an switching power supply and in the output stage a series linear voltage regulator (LM1764A) to remove the ripp...

Descriptions. This cable conects betweeen any PL-xxx sensor to the Hub X2-V2, or any BEC from from the PL and PC Series.

Larger Pitot Tube Screw mounting with tube Specifications Pitot Tube M3x10 screws 1m Tube

Latest appearance of 65mm 1S brushless frame for Meteor65 Brushless Whoop Quadcopter. With a marvellous design on battery slot which keeps a low pr...

Want a 1S whoop outdoor, around the house and yard, like the 2S 75X or Mobula75 in 2018 winter? Look no further!BetFPV Meteor75 is all you need.1S ...

PREORDERS OPEN NOW - Stock arriving 23 April 2019 Set of four arms for the Micro Alien Frame Can use up to a 3" prop with these arms. 

These Micro GPS uses multi-constellation GNSS powered by u-blox M10, a concurrent GNSS receiver which can receive and track multiple GNSS systems. ...

The Micro-Nano Module Adapter is designed to connect modules with a Nano port to the JR/Micro port's Radio transmitter. Notably, it supports the r...