support@flyingrobot.co.za
support@flyingrobot.co.za
Save 0%
Save %
The PDB-40A has been engineered to provide the highest possible performance and reliability in a 36*57mm 4 layers PCB. 4oz copper,4-layers&1.0...
View full details
Sold out
The mini carrier board incorporates a ‘ power selection module ‘ (PSM with a value of €40). This module provides redundancy for the Pixhawk 2.1 c...
View full details
Save up to 0%
Save %
The EchoUAS XT30 power distribution board is a simple way to provide power to other electronic components on your drone, robot, rover, or plane. T...
View full details
Sold out
PDB KIT 4oz Copper - 2mm PCB XT-60 pair and spacer (9x) M3 Press nut - Stainless Steel PDB Weight including 4 press nuts 15g XT-60 Weight 3...
View full details
Save 0%
Save %
Connection Cable KISS FC / FC V2-> 24A PDB KISS FC / FC V2-> 25A 4in1 ESC Connection Cable to connect the KISS FC / FC V2 to the KISS Carri...
View full details
Sold out
PDB Input voltage range: 6~60V (2~12S LiPo) PDB/current sense resistor: 140A cont, 264A burst. ESC power pads: 60A cont. 100A burst 6x ESC power /s...
View full details
Save 0%
Save %
Wide 9V to 55V Operating Input Range with TVS protection 3x independent Step-Down Voltage Regulators BEC Vx, 5.2V / 6V / 8V output options. supp...
View full details
Save 0%
Save %
Specifications 9V to 55V Operating Input Range Vx for servos, 5V, 6V, 8V Adj. Default is 5V. Synchronous switching step-down (buck) regulator w...
View full details
Sold out
Spare Parts-X500 V2 Kit
Save 0%
Save %
Description PM02D provides regulated power supply for your Pixhawk® 5X & 6X from the battery, as well as current consumption and battery volta...
View full details
Save 0%
Save %
DESCRIPTION Power module for The Cube (Pixhawk 2.1) This Power Moduleis a simple way of providing your PixHawk 2.1 with clean power from a LiPo ...
View full details
Save 0%
Save %
The Power Management Board (PM Board) serves the purpose of a Power Module as well as a Power Distribution Board. In addition to providing regulate...
View full details
Sold out
Description: PM02 is a simple way of providing your APM and Pix32 with clean power from a LiPo battery as well as current consumption and battery v...
View full details
Sold out
Product DescriptionPower inputs must be between 4.4v and 5.7vPower output is the same voltage as the selected input.Power can be taken off the PSM ...
View full details