X500 V2 Drone Kit with Pixhawk 6C with M10 GPS and 433MHz Telemetry

Feature:

• All new Pixhawk 6C Flight Controller with M10 GPS Module and Plug & play SiK Telemetry Radio
• New frame design with minimal assembly time (~30 minutes), No soldering required
• Carbon Fiber frame with fiber-reinforced nylon connectors providing easy & straightforward installation
• Pre-installed motors & ESCs with simple XT30 power plugs for PDB
• Power distribution board (PDB) with XT60 & XT30 plugs 
• Mount for companion computer such as Raspberry Pi & Nvidia Jetson Nano
• Optional depth camera mount for Intel RealSense & Structure Core

Note:

• The Pixhawk 6C version now ships with PM02D-HV (High Voltage) version. In PX4, you must set SENS_EN_INA228 to enable this. This HV version is only supported in ardupilot 4.4 & later. Setup Guide can be found here.

• Firmware Support for M10 GPS: PX4 1.14 and ArduPilot 4.3 or newer is required.

PX4 Development Kit - X500 v2 Includes:

• Autopilot Flight controller: Pixhawk 6C (Plastic case ) & PM02
• M10 GPS Module
• SiK Telemetry Radio V3  433MHz
• X500 V2 Frame Kit 
• Preinstalled Items:
  • Motors - Holybro 2216 KV920 Motor (4 pcs) with XT30 Plug 
  • ESCs - BLHeli S ESC 20A (4 pcs) with XT30 Plugs - Compatible with 4S Battery
• 1045 Propellers (6 pcs)
• Power Distribution Board (XT60 plug for battery & XT30 plug for ESCs & peripherals)
• Other Optional Items (Sold Seperately) 
  • RadioMaster TX16S RC Controller
  • RadioMaster R81 Receiver
  • Depth Camera Mount

X500 V2 Frame Kit Details (SKU30120):

• Body - Full Carbon Fiber Top & Bottom plate (144 x 144mm, 2mm thick)
• Arm - High strength & ultra-lightweight 16mm carbon fiber tubes with newly designed fiber reinforced nylon connectors
• Landing gear - 16mm & 10mm diameter carbon fiber tubes with strengthened & improved plastic tee connectors.
• Platform board - With mounting holes for GPS & popular companion computer such as the Raspberry Pi 4 & Jetson Nano
• Dual 10mm Ø rod x 250 mm long rail mounting system
• Battery mount with two Battery Straps
• Hand tools for installation

Mechanical Specification:

• Wheelbase: 500mm
• Motor mount pattern: 16x16mm 
• Frame Body: 144x144mm, 2mm thick
• Landing gear height: 215mm
• Space between top and bottom plates: 28mm
• Weight: 610g
• Flight time: ~18 minutes hover with no additional payload. Tested with 5000mAh Battery.
• Payload: 1500g (without Battery, 70% Throttle)
• Battery Recommendation: 4S 3000-5000mAh 20C+ with XT60 Lipo Battery (Not Included)