Skip to content
Free Shipping for orders over R1000*
Free Shipping for orders over R1000*
On Sale Gift Cards Wishlist
Hex Black Cube Combo

Hex Black Cube Combo

Sold out
R 7,825.22 - R 7,825.22
R 7,825.22
R 7,825.22 - R 7,825.22
R 7,825.22
Currently unavailable
Add to Wishlist

The Cube autopilot is a further evolution of the Pixhawk autopilot. It is designed for commercial systems and manufacturers who wish to fully integrate a autopilot into their system. On top of the existing features of Pixhawk, it has the following enhancements:

  • 3 sets of IMU sensors for extra redundancy
  • 2 sets of IMU are vibration-isolated mechanically, reducing the effect of frame vibration to state estimation
  • IMUs are temperature-controlled by onboard heating resistors, allowing optimum working temperature of IMUs
  • The entire flight management unit(FMU) and inertial management unit(IMU) are housed in a relatively small form factor (a cube). All inputs and outputs go through a 80-pin DF17 connector, allowing a plug-in solution for manufacturers of commercial systems. Manufacturers can design their own carrier boards to suite their specific needs.

Specifications

  • Processor
    • 32-bit ARM Cortex M4 core with FPU
    • 168 Mhz/256 KB RAM/2 MB Flash
    • 32-bit failsafe co-processor
  • Sensors
    • Three redundant IMUs (accels, gyros and compass)
    • InvenSense MPU9250, ICM20948 and/or ICM20648 as first and third IMU (accel and gyro)
    • ST Micro L3GD20+LSM303D or InvenSense ICM2076xx as backup IMU (accel and gyro)
    • Two redundant MS5611 barometers
  • Power
    • Redundant power supply with automatic failover
    • Servo rail high-power (7 V) and high-current ready
    • All peripheral outputs over-current protected, all inputs ESD protected
  • Interfaces
    • 14x PWM servo outputs (8 from IO, 6 from FMU)
    • S.Bus servo output
    • R/C inputs for CPPM, Spektrum / DSM and S.Bus
    • Analogue / PWM RSSI input
    • 5x general purpose serial ports, 2 with full flow control
    • 2x I2C ports
    • SPI port (un-buffered, for short cables only not recommended for use)
    • 2x CAN Bus interface
    • 3x Analogue inputs (3.3V and 6.6V)
    • High-powered piezo buzzer driver (on expansion board)
    • High-power RGB LED (I2C driver compatible connected externally only)
    • Safety switch / LED
    • Optional carrier board for Intel Edison

Package includes:

1 x Black Cube

1 x Carrier Board with ADSB

1 x Cube Cable Set

1 x Power Brick and cables

Plus screws