support@flyingrobot.co.za
support@flyingrobot.co.za
Sold out
Specifications Power dissipation: 45mA(binding), 85mA(wifi mode) RF Frequency: 2.4GHz (2400~2480MHz) Input voltage: 4~9V DC @ 5V pad Receiver pro...
View full details
Sold out
ExpressLRS firmware, 2.4GHz, 7x PWM outputs, Variometer sensor integrated. Specific for the Gliders and other fixed-wings. Small in form factor, ...
View full details
Sold out
Perfect for wings and planes, the Matek F405 HDTE FC will work with whatever firmware you would like. Betaflight, INAV, and Ardupilot are all comp...
View full details
Save 0%
Save %
Specifications MCU: 168MHz STM32F405RGT6 IMU: ICM42688-P (SPI) Baro: SPL06-001 (I2C) OSD: AT7456E (SPI) Blackbox: MicroSD slot (SPI) 6x UARTs, 1x...
View full details
Save 0%
Save %
FC Specifications MCU: STM32F405RGT6, 168MHz , 1MB Flash IMU: ICM42688-P Baro: SPL06-001 OSD: AT7456E Blackbox: 16M Flash 5x UARTs, 1x Softserial...
View full details
Save 0%
Save %
4x Matek FC Anti Vibration Standoffs M2
Save 0%
Save %
The new features of F405-mini TE compared with F722-mini SE(EOL) F405 has 1MB flash which can run with ArduPilot. even with INAV firmware, some ...
View full details
Sold out
M10-5883 uses multi-constellation GNSS powered by u-blox MAX-M10S. MAX-M10S supports concurrent reception of four GNSS (GPS, GLONASS, Galileo, and...
View full details
Save 0%
Save %
M9N-5883 uses multi-constellation GNSS powered by u-blox NEO-M9N , NEO-M9N is a concurrent GNSS receiver which can receive and track multiple GNS...
View full details
Sold out
Matek M8Q-5883 GPS and Compass Module perfect for fixed wing using iNAV.A Very small size GPS module perfect for when your restricted for room a...
View full details
Save 0%
Save %
Matek's H743-WING V3 Flight Controller arrives with new features and improvements over the original. This FC features a STM32H743VIT6 MCU running ...
View full details
Save 0%
Save %
The Matek H7A3-SLIM Flight Controller features STM32H7A3VI, ICM20602 & MPU6000, DPS310, OSD, 7x UARTs, 2x I2C, 1xCAN, 13x PWM outputs, BEC5V an...
View full details
Save 0%
Save %
Specifications Hall effect current sensor No voltage drop and heat on current sensor components Offset and Sensitivity are calibrated in factory C...
View full details
Save 0%
Save %
Get the voltage you need with this Matek BEC, convert 6-25V to either 5V, 9V, or 12V. This BEC defaults to 5V, select either 9V or 12V by solderin...
View full details
Sold out
Specifications Optical Flow: PMW3901 Lidar: VL53L0X Interface UART Protocol: MSP Working Range: 8cm~200cm Field of view: 42 degree(PMW3901), 27 d...
View full details
Save 0%
Save %
PDB Input voltage range: 6~60V (2~12S LiPo) PDB/current sense resistor: 140A cont, 264A burst. ESC power pads: 60A cont. 100A burst 6x ESC power /s...
View full details
Save 0%
Save %
Wide 9V to 55V Operating Input Range with TVS protection 3x independent Step-Down Voltage Regulators BEC Vx, 5.2V / 6V / 8V output options. supp...
View full details
Save 0%
Save %
Specifications 9V to 55V Operating Input Range Vx for servos, 5V, 6V, 8V Adj. Default is 5V. Synchronous switching step-down (buck) regulator w...
View full details
Sold out
FEATURES High Efficiency Synchronous Step-down regulator Wide 2-8S (6-30V) Operating Input Range Continuous load current: 1.5 Amps (Max.2.5A 5s/min...
View full details
Save 0%
Save %
FEATURES High Efficiency Synchronous Step-down regulator Wide 2-8S (6-30V) Operating Input Range Continuous load current: 1.5 Amps (Max....
View full details
Save 0%
Save %
UBEC DUO 4A/5~12V & 4A/5V This device is a high-efficiency, switch-mode buck regulator with two output channels. It works with 7~26Vdc input. ...
View full details
Sold out
9CH INTL and 2CH US version have identical hardware and layout, 2CH is locked to 1258 & 1280MHz by firmware. Features & Specifications ...
View full details
Save 0%
Save %
CANPDB w/ 4A BEC & JST-GH Splitter Specifications 6V to 55V Operating Input Range(2S-12S Li-xx) 5.2V output on “5V” pin/pads Suppor...
View full details
Save 0%
Save %
The Matek Digital Airspeed Sensor ASPD-DLVR features CAN JST-GH connector, UAVCAN Protocol UART1, UART2, UART3 among many other cool features! S...
View full details
Save 0%
Save %
M9N-G4-3100 is based on ArudPilots’ AP_Periph firmware, It is a GNSS+COMPASS peripheral with CAN/DroneCAN and UART/MSP interfaces. M9N-G4-3100 us...
View full details
Save 0%
Save %
Power Module PM12S-4A Specifications Wide 9V to 55V Operating Input Range with TVS protection 2x independent Step-Down Voltage Reg...
View full details
Save 0%
Save %
I2C-INA-BM is an ultra-precise digital power monitor based on TI INA228. The resistance of this conductive path is 200 μΩ typical, providing low p...
View full details
Sold out
200A - Current / Voltage measurement sensor board, based on Allegro Hall Sensor ACS758-200U.Voltage range is up to 20S (85V) with solder bridge ope...
View full details
Sold out
GeneralThe HYB-BEC (Hybrid BEC) is an switching power supply and in the output stage a series linear voltage regulator (LM1764A) to remove the ripp...
View full details
Save 0%
Save %
Descriptions. This cable conects betweeen any PL-xxx sensor to the Hub X2-V2, or any BEC from from the PL and PC Series.
Save 0%
Save %
Larger Pitot Tube Screw mounting with tube Specifications Pitot Tube M3x10 screws 1m Tube
Sold out
Latest appearance of 65mm 1S brushless frame for Meteor65 Brushless Whoop Quadcopter. With a marvellous design on battery slot which keeps a low pr...
View full details
Sold out
Want a 1S whoop outdoor, around the house and yard, like the 2S 75X or Mobula75 in 2018 winter? Look no further!BetFPV Meteor75 is all you need.1S ...
View full details
Save 0%
Save %
PREORDERS OPEN NOW - Stock arriving 23 April 2019 Set of four arms for the Micro Alien Frame Can use up to a 3" prop with these arms.
Save 6%
Save %
These Micro GPS uses multi-constellation GNSS powered by u-blox M10, a concurrent GNSS receiver which can receive and track multiple GNSS systems. ...
View full details
Sold out
The Micro-Nano Module Adapter is designed to connect modules with a Nano port to the JR/Micro port's Radio transmitter. Notably, it supports the r...
View full details
Save 0%
Save %
Mini Carrier Board has the standardized DF17 connector which allows user to connect it to every version of the Cube flight controller. With smaller...
View full details
Sold out
Video cable for DJI o3 air unit
Save 0%
Save %
Video cable for DJI O3 air unit.
Sold out
SERVO SPECIFICATION Torque (kg-cm) 6.0 (4.8V) / 7.5 (6.0V) / 9.2 (7.4V) / 10.2 (8.2V) Torque (oz-in) 83.3 (4.8V) / 104.2 (6.0V) / 127.8...
View full details
Sold out
SERVO SPECIFICATION Torque (kg-cm) 6.0 (4.8V) / 7.5 (6.0V) / 9.2 (7.4V) / 10.2 (8.2V) Torque (oz-in) 83.3 (4.8V) / 104.2 (6.0V) / 127.8 (7...
View full details
Save 0%
Save %
MMCX 90 Deg male to MMCX Straight Male 8cm lead
Sold out
Spare Parts-X500 V2 Kit
Save 0%
Save %
Features: Motor wire protectors to prevent from prop strikes. There are different lengths for our iFlight BNFs: 65mm: F5D and F6D rear Arms Chim...
View full details
Sold out
JX6 Quick Release Connector Male/Female MPX Connector Model: JX-6Metal material: gold-plated brassPlastic material: PAInstantaneous current: (large...
View full details
Save 0%
Save %
Specification Weight: 9.5g/pair Type:JX-9 Metal Material: Brass Gold Plated Plastic Material: PA Instantaneous current: (big) 60A/(Small) 7A Rated ...
View full details
Sold out
Finally a purpose built FPV earbud that we have engineered from the ground up to favor sound quality from onboard microphones! We hand-selected th...
View full details