support@flyingrobot.co.za
support@flyingrobot.co.za
CubePilot is an Australian company specializing in open-source autopilot systems for unmanned vehicles. They provide hardware and embedded software solutions for civilian unmanned systems, focusing on reliability and adaptability. Their flagship product, the Cube autopilot, is a core component of an ecosystem that includes various accessories and carrier boards, all developed with community and industry collaboration.
Save 0%
Save %
Herelink HD Video/Control/Telemetry Transmission System Features ICASA Approved Tested and demonstrated BVLOS to SACAA for 15KM Supports dual ...
View full details
Save 0%
Save %
Pre Order
Save 0%
Save %
Save 0%
Save %
Product Description About Cube Orange+ An integrated and single board/box all-in-one flight controller Provide sufficient interfaces...
View full details
Save 0%
Save %
This is an individual replacement Taoglas antenna for the herelink air unit.
Save 0%
Save %
The Ethernet Cable design for Herelink v1.1 Air Unit. Cable Length : 15cm
Save 0%
Save %
DESCRIPTION Power module for The Cube (Pixhawk 2.1) This Power Moduleis a simple way of providing your PixHawk 2.1 with clean power from a LiPo ...
View full details
Save 0%
Save %
New version with SD card slot and Ethernet port. Contains Air Unit Only: Appearance: core board + video daughter board + structure of RF daughter...
View full details
Sold out
Cables for accessories are JST to DF13 cables which are compatible with old pixhawk accessories, such as Telemetry, Power Brick or GPS It contai...
View full details
Sold out
This is an updated version of the original carrier board, its overall footprint is identical to the previous versions and main changes compared to ...
View full details
Save 0%
Save %
Sold out
Save 0%
Save %
1x Hex CAN or I2C bus splitter
Save 42%
Save %
The HereFlow is a lightweight (1.2g) finger-sized board that houses an optical flow sensor as well as a Lidar component. Bringing new possibilities...
View full details
Save 0%
Save %
Used for connecting Here GNSS or Here+ GNSS Rover to GPS 2 port in PH2.1 Only useful when using Here or Here+ as a secondary GPS for Pixhawk Len...
View full details
Sold out
Save 0%
Save %
CubePilot iStand is specifically designed for Here 3, Here 3+ and Here 4 GPS 1 x Stand 1 x comes with screws and Nyloc nuts
Sold out
INSIDE THE CUBE An STM32F427 Rev 3 Flight management unit. (where the flight controller lives.)An STM32F100 I/O processor with pass through capabi...
View full details
Save 0%
Save %
Mini Carrier Board has the standardized DF17 connector which allows user to connect it to every version of the Cube flight controller. With smaller...
View full details
Save 0%
Save %
Herelink Fan Set for Herelink Air UnitWhat's inside:Herelink Fan x1Herelink Screw Set x1 Herelink Silicone Ring Set x1
Save 0%
Save %
Package includes:M1.5 x 20mmPhilips head4 per pack
Save 0%
Save %
It contains: I2C Cable x2 CAN Cable x2 BUZZER Cable x1 Telem Cable (GH-GH)x2 Power Brick Mini Cable x2 GPS1 GH Cable (with safety switch) x1
Save 0%
Save %
Save 0%
Save %
20cm Power Brick Mini Cable