support@flyingrobot.co.za
support@flyingrobot.co.za
Save 0%
Save %
UBEC DUO 4A/5~12V & 4A/5V This device is a high-efficiency, switch-mode buck regulator with two output channels. It works with 7~26Vdc input. ...
View full details
Sold out
9CH INTL and 2CH US version have identical hardware and layout, 2CH is locked to 1258 & 1280MHz by firmware. Features & Specifications ...
View full details
Sold out
Description:1. 5050 Package RGB full color highlighting WS2812B lamp beads * 62. 5V active buzzer3. Voltage: 5V (4 ~ 7V)4. Size: 50 * 10mm, 3g5. In...
View full details
Sold out
CANPDB w/ 4A BEC & JST-GH Splitter Specifications 6V to 55V Operating Input Range(2S-12S Li-xx) 5.2V output on “5V” pin/pads Suppor...
View full details
Save 0%
Save %
The Matek Digital Airspeed Sensor ASPD-DLVR features CAN JST-GH connector, UAVCAN Protocol UART1, UART2, UART3 among many other cool features! S...
View full details
Save 0%
Save %
M9N-G4-3100 is based on ArudPilots’ AP_Periph firmware, It is a GNSS+COMPASS peripheral with CAN/DroneCAN and UART/MSP interfaces. M9N-G4-3100 us...
View full details
Save 0%
Save %
Power Module PM12S-4A Specifications Wide 9V to 55V Operating Input Range with TVS protection 2x independent Step-Down Voltage Reg...
View full details
Save 0%
Save %
PM20S-2 is made with 100V DC components. Support 9V to 85V DC operating Input voltage with 85V TVS protection 2x independent Step-Down Voltage Reg...
View full details
Save 0%
Save %
I2C-INA-BM is an ultra-precise digital power monitor based on TI INA228. The resistance of this conductive path is 200 μΩ typical, providing low p...
View full details
Sold out
Features & Specifications Receiving frequency: 9CH (1080MHz to 1360MHz) RX Sensitivity: -95dBm Band-pass filter 950MHz~1450MHz Dual input opti...
View full details
Sold out
The output voltage differs. Please select the version required: 1. Standard Option- 4 outputs as follows: 3 outputs x 5.3V / 10A 1 output x 12....
View full details
Sold out
200A - Current / Voltage measurement sensor board, based on Allegro Hall Sensor ACS758-200U.Voltage range is up to 20S (85V) with solder bridge ope...
View full details
Sold out
Input 4-14S LiPo / max. 60V. Output 2x 5.30V / 1x 12.0V / 3A -> +/- 0.05V –> Ripple 1mV @ 1.5A output current. Inclusive LDO power supply (...
View full details
Sold out
GeneralThe HYB-BEC (Hybrid BEC) is an switching power supply and in the output stage a series linear voltage regulator (LM1764A) to remove the ripp...
View full details
Save 0%
Save %
Descriptions. This cable conects betweeen any PL-xxx sensor to the Hub X2-V2, or any BEC from from the PL and PC Series.
Save 0%
Save %
Sold out
Larger Pitot Tube Screw mounting with tube Specifications Pitot Tube M3x10 screws 1m Tube
Sold out
Latest appearance of 65mm 1S brushless frame for Meteor65 Brushless Whoop Quadcopter. With a marvellous design on battery slot which keeps a low pr...
View full details
Sold out
Want a 1S whoop outdoor, around the house and yard, like the 2S 75X or Mobula75 in 2018 winter? Look no further!BetFPV Meteor75 is all you need.1S ...
View full details
Sold out
Meteor75 Pro features 45mm propellers, being the largest 1S whoop drone for greater thrust and lift. Comes with more powerful 1102 22000KV motors a...
View full details
Sold out
This is Crosswind 1900mm V2 platform. In Crosswind V2, the H-stab has been updated to get a better performance while the tail L-R connector is enha...
View full details