support@flyingrobot.co.za
support@flyingrobot.co.za
Save 0%
Save %
PDB Input voltage range: 6~60V (2~12S LiPo) PDB/current sense resistor: 140A cont, 264A burst. ESC power pads: 60A cont. 100A burst 6x ESC power /s...
View full details
Save 0%
Save %
Wide 9V to 55V Operating Input Range with TVS protection 3x independent Step-Down Voltage Regulators BEC Vx, 5.2V / 6V / 8V output options. supp...
View full details
Save 0%
Save %
Specifications 9V to 55V Operating Input Range Vx for servos, 5V, 6V, 8V Adj. Default is 5V. Synchronous switching step-down (buck) regulator w...
View full details
Save 0%
Save %
FEATURES High Efficiency Synchronous Step-down regulator Wide 2-8S (6-30V) Operating Input Range Continuous load current: 1.5 Amps (Max....
View full details
Save 0%
Save %
UBEC DUO 4A/5~12V & 4A/5V This device is a high-efficiency, switch-mode buck regulator with two output channels. It works with 7~26Vdc input. ...
View full details
Save 0%
Save %
CANPDB w/ 4A BEC & JST-GH Splitter Specifications 6V to 55V Operating Input Range(2S-12S Li-xx) 5.2V output on “5V” pin/pads Suppor...
View full details
Save 0%
Save %
The Matek Digital Airspeed Sensor ASPD-DLVR features CAN JST-GH connector, UAVCAN Protocol UART1, UART2, UART3 among many other cool features! S...
View full details
Save 0%
Save %
M9N-G4-3100 is based on ArudPilots’ AP_Periph firmware, It is a GNSS+COMPASS peripheral with CAN/DroneCAN and UART/MSP interfaces. M9N-G4-3100 us...
View full details
Save 0%
Save %
Power Module PM12S-4A Specifications Wide 9V to 55V Operating Input Range with TVS protection 2x independent Step-Down Voltage Reg...
View full details
Save 0%
Save %
I2C-INA-BM is an ultra-precise digital power monitor based on TI INA228. The resistance of this conductive path is 200 μΩ typical, providing low p...
View full details
Save 0%
Save %
Descriptions. This cable conects betweeen any PL-xxx sensor to the Hub X2-V2, or any BEC from from the PL and PC Series.
Save 0%
Save %
Save 0%
Save %
Larger Pitot Tube Screw mounting with tube Specifications Pitot Tube M3x10 screws 1m Tube
Save 0%
Save %
PREORDERS OPEN NOW - Stock arriving 23 April 2019 Set of four arms for the Micro Alien Frame Can use up to a 3" prop with these arms.
Save 6%
Save %
These Micro GPS uses multi-constellation GNSS powered by u-blox M10, a concurrent GNSS receiver which can receive and track multiple GNSS systems. ...
View full details
Save 0%
Save %
Mini Carrier Board has the standardized DF17 connector which allows user to connect it to every version of the Cube flight controller. With smaller...
View full details
Save 0%
Save %
Save 0%
Save %
Video cable for DJI O3 air unit.
Save 0%
Save %
MMCX 90 Deg male to MMCX Straight Male 8cm lead
Save 0%
Save %
Save up to 0%
Save %
MMCX to SMA Female Extension cable, various lengths available High temperature and acid corrosion resistant, high-frequency low-loss antenna extens...
View full details785-1000-1-ND MFG : Alpha & Omega Semiconductor Inc. (VA) / AO3400A DESC: MOSFET N-CH 30V 5.7A SOT23-3L 5.00600 50.06 COO : CHINA ECCN: EAR99 H...
View full details
Save 0%
Save %
Features: Motor wire protectors to prevent from prop strikes. There are different lengths for our iFlight BNFs: 65mm: F5D and F6D rear Arms Chim...
View full details
Save 0%
Save %
Specification Weight: 9.5g/pair Type:JX-9 Metal Material: Brass Gold Plated Plastic Material: PA Instantaneous current: (big) 60A/(Small) 7A Rated ...
View full details
Save 0%
Save %
Brand: Amass (Original Manufacturer) Body Material and Surface Plating: Brass and gold plated Insulation Material: PA66 Original Internal Resista...
View full details
Save 0%
Save %
Rated voltage: DC500V Rated current: 30A Peak current: 60A Contact Resistance: 0.50mΩ Metal material: Brass, gold plated Plastic material: PA...
View full details
Save 0%
Save %
Connector Type: 3 pin 3.5mm bullet plug. Weight: 9.6g per pair (including sleeves).
Save 0%
Save %
Save 0%
Save %
Details A set of 2 HQ propellers, 2 blade style with a 6mm center hub. They come with a set of plastic reducers (3,4,5,6 mm). They come in sets ...
View full details
Save 0%
Save %
This is the second generation Goober Canopy that works with 14x14 size fpv camera. As long as the camera board size comes with 14X14 and side scre...
View full details
Save 0%
Save %
The frame features a traditional look and geometry to maintain the flight characteristics familiar to users, ensuring easy compatibility with the B...
View full details8 x 5mm black nylon hex M3 standoffs
Save 0%
Save %
8 x 10mm black nylon hex M3 standoffs
Save 0%
Save %
This is a set of 8 nylon standoffs, in a hexagonal shape (25mm). Threaded on both ends for a M3 screw.What's included8x nylon 25mm standoffs
Save 0%
Save %
This is a set of 8 nylon standoffs, in a hexagonal shape (35mm). Threaded on both ends for a M3 screw.What's included8x nylon 35mm standoffs
Save 0%
Save %
Quality Deans connectors
10 x male connectors
Save 0%
Save %
O.S. Engine GF30 II (70T2) with F-6040 Silencer The O.S. GF30 II is the ideal choice for large-scale RC and UAV fixed-wing aircraft requiring relia...
View full details
Save 0%
Save %
Aluminium roll cage for the Obsession frame (x1)
Save 0%
Save %
Bottom plates for the V2 Obsession frame (2x)
Save 0%
Save %
FPV camera side plates for the Obsession frame (x2)
Save 41%
Save %
OCDAY 4 in 1 Multi USB Charge HUB Battery Charger for DJI TELLO UAV The 4-in-1 battery charger is designed for Tello There are 4 interfaces in the ...
View full details
Save 0%
Save %
ORT Micro Vee Linear 5.8GHz Antenna U.FL (5cm Tired of getting mediocre performance from your default antenna AIO micro camera/VTX? Try the ORT Mic...
View full details
Save 0%
Save %
2 x Samsung 30Q Li-ion INR 18650 Batteries Buy in pairs and save Huge Capacity = Less Charging With a 3000mAH capacity that makes other 18650s look...
View full details