support@flyingrobot.co.za
support@flyingrobot.co.za
Save up to 0%
Save %
Manufactured by Team BlackSheep, this antenna is your cheap entry into circular polarization. The 5dbi gain provides enough beamwidth to comfortabl...
View full details10x M3 rubber O ring for FC. H-1mm OD-5mm
Save 0%
Save %
The Lipo Killer discharges old or damaged batteries you wish to dispose of down to 0v. This eliminates all charge from the battery and makes the pa...
View full details
Save 0%
Save %
Dimensions are as follows: Outer Diameter: 7.8mm Inner Diameter: 3mm Overall Height: 2mm Countersink Diameter: 5.5mm
Save up to 0%
Save %
4x Aluminum Stack Standoff 6mm+6mm
Save up to 0%
Save %
4x Aluminum Stack Standoff 4.5mm+6.5mm M3 thread on both male and female ends.
Save 0%
Save %
4x 5mm Threaded Anodised Spacer
Save up to 0%
Save %
4x 2mm Thick M3 Threaded Anodised Spacer
Save up to 0%
Save %
5pc CW + 5pc CCW SPECIFICATION Propeller Diameter : 2.56 inch Pitch :1 Blades 2 Material : Poly Carbonate Weight : 0.46 Hub Diameter :5mm Hub Thi...
View full details
Save 30%
Save %
Don’t let the small size fool you, the BlueBeam Pro is a high performance CP antenna for your 1.3GHz which sacrifices nothing on account of its siz...
View full details
Save 0%
Save %
PREORDERS OPEN NOW - Stock arriving 23 April 2019 Set of four arms for the Micro Alien Frame Can use up to a 3" prop with these arms.
Save 30%
Save %
Cross-polarized (dual polarized) MIMO receiver antenna for diversity goggle modules. Can be mounted to goggle modules and will work like two linear...
View full details
Save 0%
Save %
Unipolar ultralight VTx antenna for miniquads and racing drones. Can be mounted using the included right angle aluminum bracket or using 3D printed...
View full details
Save 0%
Save %
Connector Type: 3 pin 3.5mm bullet plug. Weight: 9.6g per pair (including sleeves).
Save 0%
Save %
1 x Male Connector,1 x Female Connector,2 x Wire Guiding Sleeves
Save 58%
Save %
The classic 1.3GHz Crosshair from VAS has received an update. The Crosshair was always known for its power and penetration, and the Crosshair XTREM...
View full details
Save 42%
Save %
A pair of gloss white module doors for the ImmersionRC rapidFire Receiver. This version comes in gloss white to match many versions of Fat Shark go...
View full details
Save 0%
Save %
DESIGNED BY IBCRAZY This filter improves video reception for 1.2-1.3GHz video receivers in combination with TBS Crossfire. Due to the poor filteri...
View full details
Save 0%
Save %
It's a internal-heated heating core specially for TS100, tip and heater as a whole. Specifications Type: TS-ILS Quantity: 1Pc Length: approx. 1...
View full details
Save 0%
Save %
It's a internal-heated heating core specially for TS100, tip and heater as a whole. Specifications Type: TS-I Quantity: 1Pc Length: approx. 103...
View full details
Save 0%
Save %
SPECIFICATION Propeller Diameter: 5 inch Pitch: 3.1 Blades: 3 Material: Poly Carbonate Weight: 3.6g Hub Diameter: 12.5mm Hub Thickness: 6mm Shaft...
View full details
Save 0%
Save %
Connection Cable KISS FC / FC V2-> 24A PDB KISS FC / FC V2-> 25A 4in1 ESC Connection Cable to connect the KISS FC / FC V2 to the KISS Carri...
View full details
Save 0%
Save %
Please select front(Short) or back(long) arm 1x Laser S Arm
Save 0%
Save %
A pair of hand tuned antennas to be used with the TBS Crossfire 8ch diversity receiver. SMA connector.
Save 0%
Save %
2 × T10x4.5 plastic self-locking propellers (1 CW and 1 CCW)Matched to the T-motor Air 2216 880kv motors
1x CL1 SpareTop Plate
Save 30%
Save %
Compatible with all Alien PDB's
Save 0%
Save %
FEATURES The Stout bell has the same efficiency as the Silk but with more power Upgraded more powerful magnets giving the overall feel of the motor...
View full details
Save 0%
Save %
A SMA to SMA extender with magnetic base. You may use this extender on your Crossfire, 2.4gHz or 5.8gHz devices with minor signal loss SPECIFICATI...
View full details
Save up to 0%
Save %
This filter is a combination of a high-quality tempered glass and a neutral density filter (ND4). These protectors are low cost and are easily repl...
View full details
Save up to 0%
Save %
Lens is cut using industrial strength lasers. The result is a clean and extremely sharp finish absent of "Micro-scratches". (The tiny spots on your...
View full details
Save 0%
Save %
Mini Carrier Board has the standardized DF17 connector which allows user to connect it to every version of the Cube flight controller. With smaller...
View full detailsIncludes: 1x 2mm side plate
Save 0%
Save %
Magnum Hot Air Tip Round 2.5mm Magnum Hot Air Tip Flat 3.5mm Magnum Hot Air Tip Round 4.0mm
Save 0%
Save %
TBS UNIFY PRO 5G8 HV 7-PIN VTX PIGTAIL.
Save 0%
Save %
2 x CW 2 x CCW 1mm hole Brushless Micro prop30mm diameter
Save 0%
Save %
M5 aluminium CW / Right Hand / Normal Loc Nuts Pack of 4 Individual anodized aluminum M5 nylon lock nuts. Includes 4x M5 Aluminum CW Nylock Nut ...
View full details
Save 30%
Save %
The Crossfire RACE antenna is a new design for miniature setups or builds where weight is more critical than range. It will give you range about as...
View full details
Save 30%
Save %
This filter improves video reception for 1.2-1.3GHz video receivers in combination with TBS Crossfire. Due to the poor filtering on the video anten...
View full details
Save 31%
Save %
This plastic canopy is still low enough to look down between the ducts to drop thru small slots or gaps. Holds the camera securely and eliminates ...
View full details
Save 0%
Save %
This small synchronous switching step-down (or buck) regulator takes an input voltage of up to 38 V and efficiently reduces it to 3.3 V. The board ...
View full details45°throttle travel for quick throttle response Hall sensor 4 ball-bearings Adjustable tension Ideal for FPV RACING, 3D and acrobatic fixed wing, 3...
View full details
Save 0%
Save %
10cm SMA Antenna Extension cable with MMCX connector
Save 0%
Save %
1x JR servo lead 22AWG male to female 90cm
Save 0%
Save %
1x JR servo lead 22AWG male to female 60cm
Save 0%
Save %
1x JR servo lead 22AWG male to female 45cm
Save 0%
Save %
Replacement set of five silicone washers made for use on the Lumenier POPO motors. These washers slide over the motor shaft and act as a spring for...
View full details
Save 0%
Save %
FrSky Taranis 2.4g 250mm receiver antenna- Ipex 4 small type connector Specifications: Brand Name: FrSky Item Name: FrSky 250mm Antenna Length: 2...
View full details