support@flyingrobot.co.za
support@flyingrobot.co.za
CubePilot is an Australian company specializing in open-source autopilot systems for unmanned vehicles. They provide hardware and embedded software solutions for civilian unmanned systems, focusing on reliability and adaptability. Their flagship product, the Cube autopilot, is a core component of an ecosystem that includes various accessories and carrier boards, all developed with community and industry collaboration.
Herelink HD Video/Control/Telemetry Transmission System Features ICASA Approved Tested and demonstrated BVLOS to SACAA for 15KM Supports dual ...
View full details
This is an individual replacement Taoglas antenna for the herelink air unit.
Product Description About Cube Orange+ An integrated and single board/box all-in-one flight controller Provide sufficient interfaces...
View full detailsDESCRIPTION Power module for The Cube (Pixhawk 2.1) This Power Moduleis a simple way of providing your PixHawk 2.1 with clean power from a LiPo ...
View full detailsNew version with SD card slot and Ethernet port. Contains Air Unit Only: Appearance: core board + video daughter board + structure of RF daughter...
View full detailsCables for accessories are JST to DF13 cables which are compatible with old pixhawk accessories, such as Telemetry, Power Brick or GPS It contai...
View full detailsThe Ethernet Cable design for Herelink v1.1 Air Unit. Cable Length : 15cm
This is an updated version of the original carrier board, its overall footprint is identical to the previous versions and main changes compared to ...
View full details1x Hex CAN or I2C bus splitter
The HereFlow is a lightweight (1.2g) finger-sized board that houses an optical flow sensor as well as a Lidar component. Bringing new possibilities...
View full detailsINSIDE THE CUBE An STM32F427 Rev 3 Flight management unit. (where the flight controller lives.)An STM32F100 I/O processor with pass through capabi...
View full detailsUsed for connecting Here GNSS or Here+ GNSS Rover to GPS 2 port in PH2.1 Only useful when using Here or Here+ as a secondary GPS for Pixhawk Len...
View full detailsCubePilot iStand is specifically designed for Here 3, Here 3+ and Here 4 GPS 1 x Stand 1 x comes with screws and Nyloc nuts
Package includes:M1.5 x 20mmPhilips head4 per pack
Mini Carrier Board has the standardized DF17 connector which allows user to connect it to every version of the Cube flight controller. With smaller...
View full detailsIt contains: I2C Cable x2 CAN Cable x2 BUZZER Cable x1 Telem Cable (GH-GH)x2 Power Brick Mini Cable x2 GPS1 GH Cable (with safety switch) x1
Herelink Fan Set for Herelink Air UnitWhat's inside:Herelink Fan x1Herelink Screw Set x1 Herelink Silicone Ring Set x1