support@flyingrobot.co.za
support@flyingrobot.co.za
Save 0%
Save %
INSTALLATION Seperate the top and bottom board of your current Fusion module. (2 x 12pins connector) Install the upgraded board to the top board....
View full details
Sold out
Finally, after over a year of spitballing the idea of a stick-on tempered glass screen protector THE WAIT IS OVER! We present to you the ultimate...
View full details
Save 0%
Save %
NOTE: M3 (3mm) Only fits stock Taranis QX7 and X9D gimbals DetailsFrSky CNC machined Aluminum Gimbal Stick Ends for Transmitter Stick with anti...
View full details
Sold out
The iCharger 4010 Duo is the latest heavyweight addition to the iCharger range. iChargers first independent two channel charger, producing more out...
View full details
Save 0%
Save %
Please select front(Short) or back(long) arm 1x Laser S Arm
Save 0%
Save %
FEATURES The Stout bell has the same efficiency as the Silk but with more power Upgraded more powerful magnets giving the overall feel of the motor...
View full details
Save 0%
Save %
Mini Carrier Board has the standardized DF17 connector which allows user to connect it to every version of the Cube flight controller. With smaller...
View full details
Sold out
Gain: ~2,2dBiPolarization: omnidirectional with linear polarizationvSWR: lower than 1.
Save 0%
Save %
Replacement set of five silicone washers made for use on the Lumenier POPO motors. These washers slide over the motor shaft and act as a spring for...
View full details
Save 0%
Save %
These are the motors the inductrix is supplied with and not the upgraded versions. There are two varieties of motors: Clockwise - Grey plastic end ...
View full details
Sold out
The Lumenier Race Pod Cover is made from an ultra-durable Polycarbonate material and precisely injection molded. The Race Pod is a direct fit for ...
View full details
Sold out
Sold out
The FrSky air speed sensor was designed for the FrSky smart port enabled system. With its easy install it is an easy way to get air speed data. ...
View full details
Save 30%
Save %
Alloy case for Foxeer HS1177 V2 camera
Sold out
SPEKTRUM DSMX QUAD RACE SERIAL RECEIVER WITH TELEMETRY (SPM4649T) The SPM4649T quad racing serial receiver offers full-range performance with inte...
View full details
Save 0%
Save %
Features Good solderability, insulation resistance, No spattering and Non-corrosive.Widely used in electrical and electronics, solder parts like ci...
View full details
Sold out
Description Stainless Steel button head hex screws. M3 Screw 35MM Length
Save 0%
Save %
FrSky Archer Plus RS The Archer line of receivers has been enhanced further with the addition of the new Archer Plus Series. The Archer Plus Series...
View full details
Save 0%
Save %
This is a set of 8 aluminum standoffs, with a textured finish (28mm). Threaded on both ends for a M3 screw. What's included 8x aluminum 28mm s...
View full details
Sold out
Spare Parts-X500 V2 Kit
Save 0%
Save %
Sold out
The T-Motor P60A V2 is a powerful 3-6S 4-in-1 128K ESC with 128K PWM and BLHeli_32 firmware that supports Dshot2400. VIDEO: TMOTOR P60...
View full details
Save 0%
Save %
With 32-bit high resolution, ultra-response technology and wide voltage operation, the mighty micro-sized D89MW delivers solid power in a lightweig...
View full details
Save 0%
Save %
Dimensions are as follows: Outer Diameter: 7.9mm Inner Diameter: 3mm Overall Height: 2mm Countersink Diameter: 6mm
Save 0%
Save %
Product Details Detachable Large Pitot Tube End Screws out Rear thread 10mm
Sold out
IMPROVED EFFICIENCY Longer Flight time due to improved propeller efficiency. Get extra flight time per battery to unleash the full potential of t...
View full details
Save 0%
Save %
Save 0%
Save %
Sold out
The output voltage differs. Please select the version required: 1. Standard Option- 4 outputs as follows: 3 outputs x 5.3V / 10A 1 output x 12....
View full details
Save 0%
Save %
The frame features a traditional look and geometry to maintain the flight characteristics familiar to users, ensuring easy compatibility with the B...
View full details
Sold out
Description Durable 5.8G antenna for Analog or Digital FPV. The perfect upgrade part for your DJI Air Unit to avoid buying fragile stock antennas...
View full details
Save 0%
Save %
Propeller Diameter: 5inch Pitch : 3.7 Blades : 3Material : Poly Carbonate Weight :4gHub Diameter :13.3mm Hub Th...
View full details
Sold out
RP-SMA Female Antenna Extension cable with MMCX connector
Sold out
Cable Type: RG316