support@flyingrobot.co.za
support@flyingrobot.co.za
Save 0%
Save %
Wide 9V to 55V Operating Input Range with TVS protection 3x independent Step-Down Voltage Regulators BEC Vx, 5.2V / 6V / 8V output options. supp...
View full details
Save 0%
Save %
Specifications 9V to 55V Operating Input Range Vx for servos, 5V, 6V, 8V Adj. Default is 5V. Synchronous switching step-down (buck) regulator w...
View full details
Sold out
FEATURES High Efficiency Synchronous Step-down regulator Wide 2-8S (6-30V) Operating Input Range Continuous load current: 1.5 Amps (Max.2.5A 5s/min...
View full details
Save 0%
Save %
FEATURES High Efficiency Synchronous Step-down regulator Wide 2-8S (6-30V) Operating Input Range Continuous load current: 1.5 Amps (Max....
View full details
Save 0%
Save %
UBEC DUO 4A/5~12V & 4A/5V This device is a high-efficiency, switch-mode buck regulator with two output channels. It works with 7~26Vdc input. ...
View full details
Sold out
9CH INTL and 2CH US version have identical hardware and layout, 2CH is locked to 1258 & 1280MHz by firmware. Features & Specifications ...
View full details
Sold out
Description:1. 5050 Package RGB full color highlighting WS2812B lamp beads * 62. 5V active buzzer3. Voltage: 5V (4 ~ 7V)4. Size: 50 * 10mm, 3g5. In...
View full details
Sold out
CANPDB w/ 4A BEC & JST-GH Splitter Specifications 6V to 55V Operating Input Range(2S-12S Li-xx) 5.2V output on “5V” pin/pads Suppor...
View full details
Sold out
The Matek Digital Airspeed Sensor ASPD-DLVR features CAN JST-GH connector, UAVCAN Protocol UART1, UART2, UART3 among many other cool features! Spe...
View full details
Save 0%
Save %
M9N-G4-3100 is based on ArudPilots’ AP_Periph firmware, It is a GNSS+COMPASS peripheral with CAN/DroneCAN and UART/MSP interfaces. M9N-G4-3100 us...
View full details
Save 0%
Save %
Power Module PM12S-4A Specifications Wide 9V to 55V Operating Input Range with TVS protection 2x independent Step-Down Voltage Reg...
View full details
Save 0%
Save %
PM20S-2 is made with 100V DC components. Support 9V to 85V DC operating Input voltage with 85V TVS protection 2x independent Step-Down Voltage Reg...
View full details
Save 0%
Save %
I2C-INA-BM is an ultra-precise digital power monitor based on TI INA228. The resistance of this conductive path is 200 μΩ typical, providing low p...
View full details
Sold out
Features & Specifications Receiving frequency: 9CH (1080MHz to 1360MHz) RX Sensitivity: -95dBm Band-pass filter 950MHz~1450MHz Dual input opti...
View full details
Sold out
The output voltage differs. Please select the version required: 1. Standard Option- 4 outputs as follows: 3 outputs x 5.3V / 10A 1 output x 12....
View full details
Sold out
200A - Current / Voltage measurement sensor board, based on Allegro Hall Sensor ACS758-200U.Voltage range is up to 20S (85V) with solder bridge ope...
View full details
Sold out
Input 4-14S LiPo / max. 60V. Output 2x 5.30V / 1x 12.0V / 3A -> +/- 0.05V –> Ripple 1mV @ 1.5A output current. Inclusive LDO power supply (...
View full details
Sold out
GeneralThe HYB-BEC (Hybrid BEC) is an switching power supply and in the output stage a series linear voltage regulator (LM1764A) to remove the ripp...
View full details
Save 0%
Save %
Descriptions. This cable conects betweeen any PL-xxx sensor to the Hub X2-V2, or any BEC from from the PL and PC Series.
Save 0%
Save %
Save 0%
Save %
Larger Pitot Tube Screw mounting with tube Specifications Pitot Tube M3x10 screws 1m Tube